Minox DC 1011 User's Guide download pdf (Page 21)

EN-21

Charging the Battery

Using the AC power adapter may charge the battery or operate the camera as power supply. Make sure

that the power of the camera is off and then insert the battery before starting.

1. Insert one end of the AC power adapter into the DC IN 5V

terminal of the camera.

2. Insert the other end of the AC power adapter into a wall outlet.

J The status LED flashes green when charging is started and

lights green when charging is completed. The LED lights red

when a charging error has occurred.

J It is recommended to fully discharge the battery before

recharging.

J Charging time varies according to the ambient temperature

and the status of battery.

J This camera must be used with specified AC power adapter. Damage caused by the use of an

incorrect adapter is not covered under the warranty.

J Always make sure that the camera is off before removing the battery.

J The battery may feel warm after it has been charged or immediately after being used. This is

normal and not a malfunction.

J When using the camera in cold conditions, keep the camera and battery warm by storing it in a

warm place such as an interior pocket between shots.

J If you open the battery cover without removing the battery, the battery power will not be

disconnected.

J If you remove the battery, you have to insert the battery within 2 hours in order to make sure that

the date and time will not be reset.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 86 87

No comments

Minox DC 1011 User's Guide Page 21