Minox DSC Instruction Manual download pdf (Page 8)

Connecting the ﬂ ash module

(DSC Flash) to the camera (DSC)

Switch both the camera and the ﬂ ash module off

before connecting the external ﬂ ash to the DSC.

Hold the ﬂ ash module with the monitor facing

upward next to the DSC with the camera controls

facing upward. Now join the two units so that

the connector of the ﬂ ash ﬁ ts into the socket of

the camera and the safety chain eye of the DSC

ﬁ ts into the mating opening on the ﬂ ash module.

To connect the two devices simultaneously press

down and gently squeeze the engaging notches.

When doing so, the notches of the ﬂ ash must en-

gage in the corresponding openings on the DSC.

Now move the slide lever on the bottom of the

ﬂ ash fully to the right (into the position “lock”),

until you hear this audibly engage. The ﬂ ash mod-

ule is now ﬁ rmly connected and engaged with

the DSC camera.

To separate the ﬂ ash module and camera again

you must ﬁ rst switch off both units. Move the slide

lever on the bottom of the ﬂ ash into the position

Slide lever Engaging notches

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 27 28

No comments

Minox DSC Instruction Manual Page 8